Autophix 7910 Bedienungsanleitung Seite 13

3. OBDII System
3.1 Read Codes
Stored codes are also known as "hard codes" or "permanent
codes". These codes cause the control module to illuminate
the malfunction indicator lamp (MIL) when an emission-related
fault occurs.
Pending Codes are also referred to as "maturing codes" or
"continuous monitor codes".
It indicates the problem that control module has detected
during the current or last driving cycle, but they are not
considered seriously.
Pending Codes will not turn on the malfunction indicator light,
and codes will be cleared from memory if there is no failure
during the following warm-up period.
1) Use the UP/DOWN scroll button to select Read Codes from
the Diagnostic Menu and press [OK].
If there are no Diagnostic Trouble Codes, the display indicates
"No (pending) codes are stored in the module!" Wait a few
seconds or press any key to return to the Diagnostic Menu.
Diagnostic Menu
Read Codes
Erase Codes
I/M Readiness
Data Stream
Evap System Test
Vehicle Information
12
1/6