Scansonic DA300 Bedienungsanleitung Seite 4

DAB auto scan
The auto scan will search for the entire DAB Band III channels. After the scan has finished, the first
alphanumerically found station will be automatically selected.
1. To activate auto scan, first press the MENU button to enter into the Tune Select Menu, then rotate the
SCROLL control to select "Autoscan", finally press on the same control to confirm, the display will show
"Scanning ..." and a progressing slide bar. (F3)
2. All the stations that have been found will be stored automatically, to explore and select listening to the found
stations, rotate the SCROLL control followed by pressing on the same control.
DAB manual tune
1. To select manual tune, first press the MENU button to enter into the Tune Select Menu, then press on the
SCROLL control to select "Manual tune". (F4) (F5)
2. Rotate the SCROLL control to move through the DAB channels, the display will show "5A to 13F" and their
associated frequencies.
3. When your desired frequency appears in the display, press on the SCROLL control to confirm. The name of
the station group (ensemble/multiplex) will be displayed.
4. To listen to the station selected, press on the SCROLL control again.
DAB secondary services
On some occasions you will see a ">" symbol directly after the name of the station, this indicates that there are
secondary services available to that station. These secondary services contain extra services that relate to the
primary station. E.g. a sports station may want to add extra commentaries. The secondary services are inserted
directly after the primary station. To select the secondary station, press on the SCROLL control.
DAB display modes
Every time you press the INFO button, the display will cycle through the following display modes:
Time and date
The time and date will be automatically updated by the broadcasted information; it is no need to set the clock
manually. In the unlikely event that no clock information is received, the display will show "<TIME/DATE>".
Frequency
The frequency of the present station will be displayed.
Audio bit rate
The display will show the digital audio bit rate being received.
Signal strength
The display will show a slide bar to indicate the signal strength, the stronger the signal, the longer the bar will be
from left to right.
DLS
DLS stands for Dynamic Label Segment which is a scrolling message that the broadcaster may include in their
transmissions. The message usually includes information such as programme details ...etc.
UK-3