Connecting To A Wired Network - HDigit Slicer Bedienungsanleitung

English

2.11 Connecting to a Wired Network

Step 1 – Choose LAN Setting
Note: make sure LAN cable connecting to LAN socket already.
→
1. Press MENU Turn SELECT to < Main Menu >, press SELECT to confirm.
2. Turn SELECT to < System settings >, press SELECT to confirm.
3. Turn SELECT to < Network >, press SELECT to confirm.
4. Turn SELECT to < Manual settings >, press SELECT to confirm.
5. While cursor point to < Wired >, press SELECT to confirm.
6. While cursor point to < DHCP enable >, press SELECT to confirm. The LAN setting is OK now!
Step 2 – Enter Internet Radio mode
→
Press MENU 'Main menu' , press SELECT to confirm, while cursor point to 'Internet Radio' , press
SELECT to confirm. Or, press MODE repeatedly until < Internet Radio > is showing up, stop pressing.
Step 3 – Access Network
Continue the above steps, few seconds later, radio can be connected to network.
If it fail to connect to network, please follow:
a. Check your Router, see it working normally or not.
b. Check your LAN cable, make sure it wasn't been damaged,
See the part of cable which inserts into the LAN socket is touching well.
20