Enter Setup Wizard; Dimmer - HDigit Slicer Bedienungsanleitung

English

10.5 Enter Setup Wizard

When this unit is started for the first time, it runs through a setup wizard to configure settings for date/time and network.
Once this has finished, the system is ready to use in most modes.
→ →
1. To run the setup wizard again, press MENU Main menu System settings
→ →
Setup wizard Yes.
2. Press SELECT to confirm 'Yes' , then step by step to set it.

10.6 Dimmer

For Power on condition:
Note: Here, high brightness level can make it easy to view the station information.
1. Press DIMMER directly to enter backlight level setting mode, when the cursor is pointing to 'Power-On Level' , press
SELECT to confirm.
2. Turn SELECT to cycle through options: 0/1/2/3.
3. Press SELECT to confirm your preferred level to clearly view your radio information, setting to the high level is
recommended for power on condition.
For Standby condition:
The setting principle above is suitable for standby condition as well, setting to a low level is recommended if you feel
comfortable and you do not want the light bothering you.
38