RUSTA 902012390101 Gebrauchsanweisung Seite 6

ENG
USING YOUR WATER KETTLE
1. Place the unit on a level surface.
2. To fill the kettle, lift the lid up carefully with your fingers, fill with the desired
amount of water, and then close the lid. Alternatively, the kettle may be filled
through the spout. The water level should not exceed MAX marks or sit below
MIN level. Too little water will cause the kettle switching off before the water
has boiled. NOTE: Do not fill the water over the maximum level, as water may
spill out of the spout when boiling. Ensure that the lid is firmly in place before
plugging in the power outlet.
3. Connect the plug into a power outlet. Press down on the On/Off switch, the
indicator will light up and the kettle will start to boil water. Once the water has
boiled, the On/Off switch will be off automatically. You can also shut off the
power by lifting the On/Off switch at any moment during boiling water. If you
want to boil water again, only press down the On/Off switch directly to restart
the kettle. NOTE: Ensure that the On/Off switch is free of obstructions and the
lid is firmly closed, the kettle will not turn off if the switch is constrained or if
the lid is opening.
4. Lift the kettle and pour your water. NOTE: Operate carefully when pouring the
water from your kettle as boiling water may result in scald, besides, don't open
the lid while the water in the kettle is hot.
5. The kettle will not re-boil until the On/Off switch is pressed down again.
NOTE: Always disconnect the power supply when not in use.
BOIL-DRY PROTECTION
Should you accidentally operate the kettle without water, the boil-dry protection
will automatically switch off the power. If this occurs, allow the kettle to cool down
completely before filling with cold water to re-boil.
6