Vitek VT-1409 W Betriebsanweisung Seite 4

ENGLISH
BEFORE THE FIRST USE
After unit transportation or storage under
cold (winter) conditions, it is necessary to
keep it for at least two hours at room tem-
perature before switching on.
Unpack the unit and remove any stickers that
–
can prevent unit operation.
Check the unit for damages; do not use it in
–
case of damages.
Make sure that the operating voltage of the
–
unit corresponds to the voltage of your mains.
Wash the hooks (6) the beaters (7) and the
–
bowl (12) with warm water and neutral deter-
gent, rinse them and dry.
Clean the mixer body (4) and base (10) with a
–
soft, slightly damp cloth, and then wipe it dry.
HOOKS ANS BEATERS
Dough hooks (6)
Use the hooks (6) for kneading yeasted dough,
mixing minced meat etc.
Mix dry ingredients for the dough at the speed
«1-2», when kneading dough, increase or
decrease the hooks' (6) rotation speed with the
operation mode switch (2).
Beaters (7)
Use the beaters (7) for beating cream and egg
white, making biscuit dough, puddings, cock-
tails, cream, mayonnaise, puree and sauces and
for mixing liquid products. The recommended
speed operation modes are 3, 4, 5, «TURBO».
Notes:
Check if the hooks (6) and beaters (7) are
–
attached properly. The hook and the beater
are equipped with a gear intended for rotat-
ing the bowl (12). Insert the attachment with
the gear into the socket (5) marked with the
symbol « ».
Do not use the beater (7) together with the
–
hook (6).
Do not block the ventilation openings on the
–
mixer body during the operation; this may
lead to the electric motor overheating.
Maximal continuous operation time is no
–
more than 4 minutes. Make at least a 20 min-
ute break before switching the unit on again.
USING THE MIXER
Before installing the hooks (6) or beaters (7)
–
make sure that the switch (2) is set to the posi-
tion «0» and the plug is not inserted into the
mains socket.
VT-1409.indd 4
Press and hold down the button (11), lift the
–
support (8) and release the button (11).
Set the bowl (12) on the base (10).
–
Install the hooks (6) or the beaters (7) into the
–
sockets (5). Insert the hook or the beater with
the drive gear into the socket marked with
the symbol « ». Make sure that the attach-
ments are fixed properly.
Press and hold down the button (9), place the
–
mixer (4) on the support (8) and release the
button (9). Make sure that the mixer (4) body
is fixed properly on the support (8).
Press and hold the button (11), lower the sup-
–
port (8) with the installed mixer to the horizon-
tal position, release the button (11).
Put the necessary ingredients into the bowl
–
(12).
Insert the power plug into the mains socket.
–
Switch the mixer on with the switch (2) setting
–
the attachment rotation speed from «1» to «5»
(see the table). To switch the maximal rotation
speed on during the mixer operation, press
and hold the «TURBO» button (1).
Do not hinder rotation of the bowl (12) during
–
the unit operation.
After the unit operation is finished, set the switch
–
(2) to the position «0» and unplug the unit.
Press and hold down the button (11), lift the
–
support (8) and release the button (11).
Press and hold down the button (9), remove
–
the mixer (4) from the support (8).
Hold the hooks (6) or the beaters with one
–
hand, press the attachment release button (3)
with the other and remove the attachments.
Remove the bowl (12) from the base (10).
–
Note: You can use the unit as a handheld mixer;
for this install the hooks (6) or beaters (7) and
use a suitable bowl.
RECOMMENDED OPERATION MODES
Speed
1, 2 Mixing dry ingredients.
Making mashed vegetables
and different sauces. Mixing
2, 3
ingredients for dough (e.g. butter
with sugar) and kneading dough.
Making "light" dough for biscuits,
3, 4
puddings etc.
4, 5, Beating – e.g. cream, milk, egg
«TURBO» whites or egg whites with yolks.
4
06.06.2014 9:08:06