Endress+Hauser Liquicap M Montage- Und Demontageanleitung Seite 8

EA0012F/00/a2/11.08
Mounting the cable to the housing
As example:
housing F16
Plug connection
housing
F15, F16, F17
Sensor in separate version
FMI51, FMI52, FTI5x
0 0 2 2 1 1
4
14
13
8
Mounting set
(disc only for
housing F16)
View from above
inside the housing
9
11
10
7
Threaded connection
housing F13
6
Any repair of a certified instrument must be documented! Any repair of a certified instrument must be documented!
This includes stating the serial number of the instrument, date of repair, type of repair and repair technician. This includes stating the serial number of the instrument, date of repair, type of repair and repair technician.
Exchange of cable on Liquicap M/Solicap M - separate version
Mounting:
6
Lightly grease the O-ring and slide it over the
sensor head
(Lubrication grease "Syntheso Glep 1",
manufacturer: Klüber Lubrication).
7
Mount the sensor to the housing
• housing F15, F16, F17:
plug housing on sensor adapter
• housing F13:
Screw housing on the sensor adapter, tighten
it.
Place the circlip ring in the mounting adapter.
8
Put the mounting elements (disc only for
housing F16) in the housing and slide it over the
sensor adapter.
Take care to the correct position of the groove
and guiding.
Place the circlip ring with the circlip pliers in the
9
top groove of sensor adapter.
All parts are now connected and can be rotated
12
together (270° from stop to stop).
Plug the green/yellow wire on the circlip ring
10
Align the cable entry and fasten the set screw,
11
torque: F15, F16 = 0.5 Nm/F13, F17 = 1.0 Nm
12 Align the sensor socket to the position of tapped
holes, see figure.
Insert the electronic insert, tighten it with the
13
two screws and connect the power supply,
signal line and ground.
14
Close the cover.
If necessary, fasten the safety clamp.
A re-calibration of the instrument is recommended.
Groove/
guiding
Tapped holes
Sensor socket
Endress+Hauser Maulburg Endress+Hauser Maulburg