Promate blueClass-2 Bedienungsanleitung Seite 4

Operation Instructions:
1. Switching blueClass-2 On/Off
• Press and hold the Multi-function Button for about 3 seconds until the Red and
Blue LED start flashing 3 times with a voice prompt "Power On"
• Again, press and hold the Multi-function Button for about 3 seconds until the
Red and Blue LED flashes 3 times with a voice prompt "Power Off"
2. Pairing blueClass-2
• Before connecting blueClass-2 to your device, make sure that blueClass-2 is in
pairing mode. In order to enter pairing mode, press and hold the Multi-function
Button for 5 seconds, until Red and Blue LED start flashing alternately.
• Turn on the Bluetooth function of the device you wish to connect and search for
"blueClass-2". From the list of found devices, select "blueClass-2".
• blueClass-2 is now connected to your device.
3. Multipoint Pairing
• Follow the above mentioned steps to pair blueClass-2 with first device and turn
off the headset.
• Then, repeat the steps to pair the second device and again, turn off the headset.
• Turn On the headset, but do not enter into pairing mode, the headset will
automatically connect to both the devices.
4. Call Function
• Answering a Call:
• Rejecting a Call:
• Ending a Call:
Press the Multi-function Button once to end an ongoing call.
• Redial Function:
to redial the last dialed call.
• Call Transfer: When talking through blueClass-2, double tap the Multi-function
Button to switch your call back to your device. Again, double tap the
Multi-function Button to switch your call back to blueClass-2.
• Mute Call:
During an ongoing call, long press and hold the Volume "-" Button to
mute the microphone. Then, long press and hold the Volume "+"Button to
un-mute the microphone.
Press the Multi-function Button once to answer an incoming call.
Long press the Multi-function Button to reject an incoming call.
Under standby mode, press and hold the Multi-function Button
English
3