End Of Operation - Taski Ergodisc series Original Bedienungsanleitung

End of operation

• Release the operating lever.
• Remove the plug from the mains socket.
Attention:
The machine must now be emptied and
cleaned. Switch off the machine (main
switch) and remove the plug from the
mains socket.
• Tilt the machine slightly backwards.
• Using your hand or foot, rotate the
tool away from the tool connection.
• Put the machine slowly on the pro-
tective ring.
• Pull the adjusting lever and tilt the
guide bar slowly upwards until it is
completely upright.
• Release the adjusting lever to lock
the guide bar.
• Clean the main cord with a damp
cloth and roll the cord loosely around
the machine handle and cable hook.
Emptying the cleaning solution
Notice:
Drain water or cleaning solution must be
disposed of in compliance with the nation-
al regulations.
Notice:
When draining the recovery tank, the reg-
ulations of the detergent supplier regard-
ing personal protective equipment must be
observed.
• Remove the water tank from the machine and empty it.
• Empty the product tank of the dispensing unit.
76
Notice:
For the procedure for emptying the foam
generator see the Instructions for use for
the foam generator 2.
Cleaning the tool
Notice:
Clean the brush whenever cleaning work
is completed.
• Clean the tool with water using a brush.
• Rinse the product tank and the spray unit thoroughly with
warm water.
The cleaning solution may dry up and cause a malfunction
of the machine.
Cleaning the pad
• Put the pad in a cleaning solution for a few hours and rinse
it thoroughly afterwards.
Notice:
The pad can also be cleaned in the wash-
ing machine at max. 40°C.
• Leave the pad to dry.
Attention:
Do not tumble-dry the pad!
Cleaning the machine
Attention:
Never clean the machine with a high-pres-
sure cleaner or water jet.
Water ingress in the machine may cause
considerable damage to the mechanical or
electrical parts.
• Wipe the machine with a moist cloth.
Storing / parking the machine (not in operation)
Notice:
The machine must be switched off and the
plug must be removed from the mains
socket.
Notice:
Store the machine with the tool lifted.