Prior To Commissioning - Taski Ergodisc series Original Bedienungsanleitung

Prior to commissioning

Brush installation
Before inserting, please check:
• that the brush does not fall below the red marking (bristles)
or 1cm of bristle length.
• the pad for wear and cleanliness before use.
Attention:
Do not use brushes which have reached
their wear limit. The wear limit is indicated
by the length of the red bristle. Do not use
worn or contaminated pads. Use original
TASKI brushes only. Failure to observe
these instructions may result in inade-
quate cleaning results or even floor dam-
age.
• Put the tool on the floor in line with
the machine.
• Stand behind the machine.
• Operate the adjusting lever at the
machine handle and lower the guide
bar slowly until your arms are
stretched out (working position).
• Release the adjusting lever to lock
the guide bar.
• Tilt the machine backwards, roll it to
the tool and lower it with the housing
over the tool.
• Tilt the machine up.
• Move the machine handle to the right
and left until the tool engages.
The machine is now ready for use.
74
Application technique
Machine
Wet & basic cleaning
Spray cleaning
Wet shampooing
Dry shampooing
Buffing
Grinding
Crystallization
Machine
Wet & basic cleaning
Spray cleaning
Wet shampooing
Dry shampooing
Buffing
Grinding
Crystallization
• 1 = electrical spray unit cannot be fitted
• 2 = limited machine performance; is therefore not recom-
mended
• 3 = only with removed additional weight
• 4 = machine weight sufficiency limited
• 5 = application only recommended in level II (high speed)
ergodisc
165 175 200 238
yes yes yes yes
yes yes yes 1
yes yes yes 2
yes yes yes 2
yes yes yes yes
4 4 4 no
4 4 4 no
ergodisc
300 400 438 duo
no no no yes
yes yes yes yes
no no no 3
no no no 3
yes yes yes 5
no no no yes
no no no yes