Safety Instructions Specific To The Tool; Starting Operation; Charging The Integrated Rechargeable Battery - FLORABEST PRC 9.6 Bedienungs- Und Sicherheitshinweise

Safety instructions
specific to the tool
J
Check the condition of the device,
charger
11
before starting to charge the device.
Do not use the tool if any of the parts are dam-
aged. Never open the tool. Repair or replace-
ment must only be carried out by the Service
Office or an electrical expert. Damaged tools,
mains cables or mains plugs pose a danger to
life as a result of electric shock.
J
Maintenance and cleaning must only be carried
out when the tool is switched off and the battery
charger is disconnected from the mains power.
J
Never under any circumstances charge the
integrated rechargeable battery with the bat-
tery charger if damaged.
J
Only use the original battery charger to
charge the integrated battery.
J
Before connecting the battery charger to the
mains power, make sure that the mains current
is 230 V ~ 50 Hz and is equipped with a 16 A
fuse in accordance with requirements.
Caution! How to avoid injury:
J
Use the following safety gear when
operating the tool: Wear safety gog-
gles, worker safety boots and protec-
tive gloves.
J
Caution! The saw blade
runs on after the tool has
been switched off! Avoid any
contact with the rotating saw blade
J
Only remove workpieces when the saw blade
has come to a complete standstill.
J
Prevent the saw blade
contact and / or colliding with stones, metal, or
similar materials. The saw blade
wise be damaged.
J
Switch off the device immediately (by releasing
the On / Off switch
- If you strike any foreign body (e.g. a nail)
while making a cut!
- If the saw blade
7
, lead and plug
12 13
7
.
7
from coming into
7
may other-
7
):
4
becomes blocked (e.g.
General safety advice / Starting operation
by wood shavings / sawdust).
J
Never have the charger
device while you are sawing.
J
Keep out of the area in which a cut and falling
branch could hit.

Starting operation

Q
Charging the integrated
Q
rechargeable battery
The battery initially requires about 4 - 5 charging
cycles before it achieves its maximum capacity.
Starting the charging process
j
Insert the plug
j
Insert the charger
The LED on the charger
battery charge state:
1. Red: The device requires to be charged or is
being charged.
2. Green: The device is fully charged.
Ending the charging process
j
Pull the charger
j
Pull the plug
13
Only charge the rechargeable battery when it is
empty. This prevents the "memory effect" (loss of
capacity as a result of charging when only partially
discharged).
J
Never switch the device on while it is being
charged.
J
Do not allow any objects to cover the charger!
The heat generated by the charger while oper-
ating can lead to a build-up of heat!
connected to the
11
into the charging socket
13
into the mains socket.
11
indicates the device's
11
out of the mains socket.
11
out of the charging socket
GB/MT
.
2
.
2
25