Inhaltsverzeichnis
Werbung
DEFAULT
RS232 DEFAULT SETTINGS
9600 baud, no parity, 8 data bits, 1 stop bit, ACK/NACK
protocol enabled, data unpacketed, inter-character delay
disabled, host serial response timeout 2 sec., host
character timeout 200 ms
DATA FORMAT
"no read" message not transmitted, no header, terminator 1
LF, terminator 2 CR, code ID not transmitted, scan data
transmission format as is
POWER SAVE
sleep state enabled
READING PARAMETERS
good decoding beeper enabled at high frequency, aiming
system disabled
DECODING PARAMETERS
linear
code
redundancy, security level 0 for Code 128, EAN/UPC and
code 93
CODE SELECTION
Enabled codes
•
EAN 8 / EAN 13 / UPC A / UPC E without ADD ON
check digit transmitted, no conversion
•
Interleaved 2/5
no check and no transmission,
fixed length code 14 characters, no conversion
•
Standard Code 39
no check, variable length code 2-55 characters
•
Code 128, EAN 128, ISBT 128
Disabled codes
Code 93, Discrete 2/5, Codabar, MSI, RSS
type
security
level
1,
no
bi-direction
Werbung
Inhaltsverzeichnis
