Checking And Maintenance - Camp Safety GIANT Bedienungsanleitung

Belaying
Take particular care during the first metres of climbing: there is a danger that the minimum clearance distance under the
user may not be sufficient.
To feed out rope see fig.14. To feed out rope quickly see fig.15. To take in rope see fig.16. To stop a fall hold the brake side
rope firmly [10] (fig.17): the belayer must pay attention to the imbalances caused by the fall force.
Rappelling
To rappel the climber see fig.18. To rappel in the event of high rope friction or limited weight see fig.8.

CHECKING AND MAINTENANCE

Before and after each use, check the correct operation of all moving parts including the function of the spring action of the
movable cam [6], the actuating lever [4], the button for cam locking [7], the safety lever [8] and the correct operation of the
anti-panic device. Check for the presence of dirt or foreign objects that can affect or prevent operation (e.g. grease, grit,
sand, pebbles, etc.).
Cleanliness: use a damp cloth (fresh water) and clean all the visible parts, then dry. Do not use solvents. Do not submerge
the product in water. After cleaning, lubricate the visible pins of the moving parts with a silicone-based lubricant spray.
Note: cleaning and lubrication are recommended after each use in a marine environment.
REVISION
In addition to the normal inspection required before, during and after each use, this product must be inspected by a skilled
person every 12 months, starting from date the product is first used; this date and the subsequent checks must be
recorded on the product's life sheet: keep this literature for inspection and reference for the life of the device. Check the
legibility of the product's markings.
In case of one of the following defects are present, the product should be withdrawn from service immediately:
Ÿ Presence of cracks on any component,
Ÿ Presence of permanent deformations on any component,
Ÿ Unauthorised modification to the product (welding, drilling, etc.),
Ÿ Corrosion that severely affects the surface state of the metal which does not disappear after slight rubbing with emery
paper,
Ÿ Malfunction of the mechanisms of the actuating lever [4], the movable cam [6], the button for cam locking [7], the safety
lever [8],
Ÿ Burrs and/or sharp edges on any surfaces that could come in contact with the rope; especially on the movable cam [6],
the fixed cam [5], the front plate [2], and the rear plate [1],
Ÿ Disappearance of the wear-and-tear indication line of the mobile cam [6],
28