Automatic Operation; Manual Operation - Fiamma F45eagle Montage- Und Gebrauchsanleitung

FIAMMASTORE
8B
M
3x
M N
N
9 - USE OF THE PRODUCT
EN
STANDARD OPERATION
The Control system key opens or closes the awning; taking your fi nger away from the button, the
movement stops. Do not put your hands in the mechanical parts of the awning, when the awning is
moving.

AUTOMATIC OPERATION

The EAGLE is equipped with the Sismic Sensor that, when the awning is open, detects the oscillatory
movements of the front bar and, when the movement exceeds the set threshold (eg In case of strong
wind), automatically closes the awning so as to preserve it. During the automatic closing of the awning,
don't stop the movement! You can't stop nor reopen it. Once stopped the closing cycle, with the lead
bar closed, you can reopen the awning. Given the automatic operation, make sure there are no obstacles
during the closing.The lead bar must close completely and the Micro-switch must be activated to interrupt
the motor. If this is not the case, contact a service centre as a matter of urgency
In case that the movement doesn't stop, you could indentify why the Microswitch doesn't work (because
is not connected or defective); in this case the lead bar will fi nish the operation until the closing and it will
trigger the protection fuse (that will safeguard the electrical system).
While closing of the lead bar automatically, do not insert your hands or objects that can hamper the
movement.
Pay attention even to non – visible objects (F.I. branches above the awning Fabric) that can hamper the
movement even before that the Microswitch takes action; in this case the protection fuse triggers and
safeguard the electrical system.
Once the fuse triggers, it must be replaced with an identical (Fuse T 6.3 A L 250 V). Never use a different
fuse. We recommend that you carry a spare fuse at all time.
In these cases, we always recommend that you contact the Service Centre.
Regulation of the sensivity of the sismic sensor
The potentiometer for sensitivity adjustment controls the sensitivity of the Sismic Sensor so as to be
able to operate on this parameter; higher numbers lower the sensitivity and vice versa.
The factory set value is 5; setting on 0 (zero) you turn off the sensor.

MANUAL OPERATION

It is possible to close the awning by passing the 12V operation (with the Control System); to do this,
please use crank handle D delivered as standard.
32