ECG IV 2920 Slim Bedienungsanleitung Seite 51

NOTICE: Maximum pot diameter is 30 cm! The pot must be placed only on the induction area. Under no
circumstances should there be a contact with the plastic parts of the device, such as the display panel!
This may damage the entire panel and reduce the functionality of the entire unit.
The induction cooktop is ready for cooking almost immediately. Never place empty pots/pans on the ceramic
glass cootop. Always place the pot/pan in the center of the induction zone, otherwise the lower part of the pan
is unevenly heated and food in the pan may burn.
Unsuitable pots: ceramic, glass, aluminum, pots/pans with rounded bottom or with diameter less than 12 cm
or more than 30 cm.
INSTRUCTIONS FOR USE
Place the induction cooktop on a flat surface so that the air inlet and outlet openings are not obstructed. The
distance between the induction cooktop and the wall must be at least 10 cm.
Small hotplate
1) Switching on
1. When the induction cooktop is connected to the mains, an acoustic signal sounds and the display shows
"OFF".
2. By pressing the on/off button, the display shows "ON" and the induction cooktop switches from standby
to heating mode.
3. The induction hob detects if you are using correct cookware. If yes, when the "ON" indicator appears on the
display, press the "Function" button and you can select the cooking setting, the cooktop turns on.
4. Otherwise, you cannot set cooking by pressing the "Function" button. A repeated beep sounds and
warning E0 appears on the display. The induction hob will switch to standby mode after 40 seconds.
2) Setting the power level
1. Pressing the "Function" button lights up the "Power" power level indicator.
2. After switching on, the power level is automatically set to 1300 W.
3. Use the "+/-" buttons to set the desired power level in the range of 200–1300 W (10 settings in total).
3) Setting the temperature
1. Press the "Function" button twice and the set temperature indicator "°C" lights up.
2. After switching on, the temperature is automatically set to 240 °C.
3. Use the "+/-" buttons to set the temperature to the desired level between 60–240 °C (10 settings in total).
4) Setting the timer
• Press the "Timer" button and set the desired time with the "+/-" buttons between 0 and 180 minutes. The
appliance automatically turns off after the time elapses.
5) Switching off
1. After you are finished cooking, switch off the induction hob by pressing the on/off button; the display will
show "OFF". The fan will still run for a while to cool the appliance.
2. When the fan stops, disconnect the appliance from the power outlet and let it cool entirely.
Large hotplate
1) Switching on
1. When the induction cooktop is connected to the mains, an acoustic signal sounds and the display shows
"OFF".
2. By pressing the on/off button, the display shows "ON" and the induction cooktop switches from standby
to heating mode.
3. The induction hob detects if you are using correct cookware. If yes, when the "ON" indicator appears on the
display, press the "Function" button and you can select the cooking setting, the cooktop turns on.
GB
51
51 51