Troubleshooting - ION Digital LP Schnellstartanleitung

Playback
You can listen to the music on your computer through its internal speakers or through headphones
connected to it. (Digital LP cannot be used as a playback device for your computer's audio.)
To listen to a record while it's playing, listen through your computer's speakers, or connect Digital LP's
RCA outputs to a stereo system or powered speakers. Do not connect them to phono-level inputs; Digital
LP's RCA outputs are line-level and could damage a device with phono-level inputs.
Tip: If there is no sound being heard through your external speakers (not Digital LP), try turning the volume
knob on Digital LP clock-wise.

Troubleshooting

If you experience any difficulties, please refer to the troubleshooting steps below as well as those in the EZ
Vinyl/Tape Converter manual included with this product.
If you are recording to a computer:
o Make sure that Digital LP is powered on and that the needle is on the record.
o Make sure Digital LP is selected as your computer's default recording device (see the instructions
below).
o If you are listening through your computer's speakers, make sure those speakers are selected as your
computer's default playback device (see the instructions below). Alternatively, you could connect Digital
LP's RCA outputs to a stereo system or powered speakers. Do not connect them to phono-level inputs;
Digital LP's RCA outputs are line-level and could damage a device with phono-level inputs.
(Note: The RCA outputs monitor the signal coming out of the turntable, not the signal coming from your
computer.)
o Disconnect then reconnect the USB cable connecting Digital LP to your computer.
I'm not hearing any audio when playing music:
• If you are playing music from vinyl:
o Make sure that Digital LP is powered on and that the needle is on the record.
o Connect Digital LP's RCA outputs to a stereo system or powered speakers. (Do not connect them to
phono-level inputs; Digital LP's RCA outputs are line-level and could damage a device with phono-level
inputs.)
• If you are playing music from your computer:
o Make sure your software music player's volume is turned up.
o Make sure your computer's volume is turned up.
o Make sure your computer's speakers are selected as your computer's default playback device (see the
instructions below). (Digital LP cannot be used as a playback device for your computer's audio.)
I am hearing a hum through my speaker or laptop when using the turntable:
• If you are recording to a laptop:
o Please connect the laptop to a grounded power supply (3 prong)
• If you are playing through a speaker:
o Please connect to a grounded (3 prong) power supply.
My record is not playing at the correct speed; its pitch is too high or too low:
o Ensure the 33 / 45 / 78 switch is set to the correct speed for your record.
The front panel display stays on the time/date and is unresponsive when buttons are pressed:
o The unit is in ERP standby mode. Press and release the power button to resume normal operation.
"No DAB Station" is seen on the display screen:
o Adjust the antenna and rescan for DAB stations.
o There are no DAB stations in your area.
9