Connection Diagram; Troubleshooting - ION QUICK PLAY LP Kurzanleitung

CONNECTION DIAGRAM

SPEAKERS
IMPORTANT WARNING:
RCA outputs are LINE-level.
Please only connect
outputs to LINE-level inputs.
You may damage your receiver
if you plug in a LINE-level into a
PHONO input.

TROUBLESHOOTING

PROBLEM
I am not hearing any audio
when I am recording.
I am experiencing poor
sound quality.
When recording into my
computer on Windows Vista,
my recordings are mono
instead of stereo.
My music is playing at a
strange pitch.
When recording into my
computer on Windows 7,
music is distorted or
"clipping."
My record stopped playing
before the end of the song.
BEFORE RETURNING THE PRODUCT, please contact ION Audio for technical support:
The
these
CAUSE
Needle is not on the record.
Turntable not powered.
Cartridge connection is not
secure.
Vinyl record is dirty or
scratched.
Recording input properties in
Vista not set to "stereo".
Incorrect speed selected on
the turntable.
Your computer's recording
level is too high.
If you are playing a 45RPM
record, the Autostop feature
may have detected that the
tonearm is close enough to
the center to stop the record.
www.ionaudio.com/supporthome
Place the needle on the record.
Make sure that the turntable is connected to a computer
that is powered on.
Cartridge must be securely connected to the tonearm
whenever you are using the turntable.
Try dusting off and gently wiping the surface of the
record before playing it.
In Vista, you may need to manually specify "stereo" for
the recording input.
Go to Start Control Panel
View). Then, click on the Recording tab and highlight
the Microphone input (USB Audio Codec). Click on
Properties to bring up the input settings. Next, click on
the Advanced tab and select "2 channel, 16 bit, 44100
Hz (CD quality)" in the Default Format pull-down menu.
Lastly, click Apply to accept the settings.
Make sure that you are playing your records at the speed
they were intended to be played. Select between the
different speeds (33, 45 or 78 RPM).
Go to Start Control Panel
Sound. Click the Recording tab and select USB
Audio Codec as the default device. Click Properties in
the lower right-hand corner. In the new window, click the
Levels tab and set the slider to "4." Click OK to close
the Properties window, then click OK to close the Sound
control panel.
Set the Autostop Switch to "off."
4
COMPUTER
SOLUTION
Sound (in Classic
Hardware and Sound