Connection Diagram; Troubleshooting - ION QUICK PLAY LP Kurzanleitung

CONNECTION DIAGRAM

SPEAKERS
IMPORTANT WARNING:
RCA outputs are LINE-level.
Please only connect
outputs to LINE-level inputs.
You may damage your receiver
if you plug in a LINE-level into a
PHONO input.

TROUBLESHOOTING

Refer to the following troubleshooting scenarios if you experience difficulty recording your vinyl to your computer.
PROBLEM
I am not hearing any audio
when I am recording.
I am experiencing
sound quality.
When recording into my
computer on Windows Vista,
my recordings are mono
instead of stereo.
My music is playing at a
strange pitch.
When recording into my
computer on Windows 7,
music is distorted
"clipping."
The
these
CAUSE
Needle is not on the record.
Turntable not powered.
Cartridge connection is not
secure.
poor
Vinyl record is
scratched.
Recording input properties in
Vista not set to "stereo".
Incorrect speed selected on
the turntable.
Your computer's
or level is too high.
BEFORE RETURNING THE PRODUCT,
please contact ION Audio for technical support:
www.ionaudio.com/supporthome
Place the needle on the record.
Make sure that the turntable is connected to a computer
that is powered on.
Cartridge must be securely connected to the tonearm
whenever you are using the turntable.
dirty or Try dusting off and gently wiping the surface of the
record before playing it.
In Vista, you may need to manually specify "stereo" for
the recording input.
Go to Start
View). Then, click on the Recording tab and highlight
the Microphone input (USB Audio Codec).
Properties to bring up the input settings. Next, click on
the Advanced tab and select "2 channel, 16 bit, 44100
Hz (CD quality)" in the Default Format pull-down menu.
Lastly, click Apply to accept the settings.
Make sure that you are playing your records at the speed
they were intended to be played. Select between the
different speeds (33, 45 or 78 RPM).
Go to Start
Sound.
Audio Codec as the default device. Click Properties in
recording
the lower right-hand corner. In the new window, click the
Levels tab and set the slider to "4." Click OK to close
the Properties window, then click OK to close the Sound
control panel.
4
COMPUTER
SOLUTION
Control Panel Sound (in Classic
Control Panel Hardware and Sound
Click the Recording tab and select USB
Click on