CombiSteel 7065.0015 Gebrauchsanweisung Seite 7

KAM 22 and KAM 40 Foamy Ayran Dispensers: Removing and cleaning of the foam making apparatus.
"Rinse all removed parts thoroughly with warm water. Parts which are not cleaned after each use may cause
bacteria formation and this may result in spoiling of the drink in the bowl."
Disassembly of the foam apparatus
Pull-up the white part of the faucet hose and
disconnect it from the gray part. (picture 6).
Pull down the white part and disconnect it from
the hose. (Picture 6.1).
Turn the foaming chamber clockwise to release
it from the tabs and pull it toward you.
Pull out the black impeller
Rotate clockwise the part to which the foaming
container is connected to release the pins and pull
them towards yourself.
Turn and place the part connected to the foaming
container to the pins, by turning it counterclockwise.
Make sure that the seal gasket is on the part,
otherwise liquid will escape to the engine.
Insert the impeller into the motor shaft and place
it forward.
Place foaming chamber and turn counterclockwise.
First insert the white part into the foaming chamber.
Connect the tap hose of the tap to the small side of
the part.
www.combisteel.com
7