Electric Schemes; Installation And Operation Of The Dispenser; Tips To Facilitate Usage - CombiSteel 7065.0015 Gebrauchsanweisung

Electric schemes

7065.0015 – 7065.0020
S1: on/off switch
M: coolant motor
Mf: fan motor
Mk: mixer motor

Installation and operation of the dispenser


Make sure that the bowl gasket (page 5 / figure 1) and the tap hose (page 6 / picture 3.1) are installed
correctly as shown.

Put the drip tray back in place.

Check that the pallet is well positioned on the shaft in the center of the bowl.

Make sure the bowl tabs are fully inserted into the bowl holders.

Your dispenser is ready for use. You can pour fruit juices which do not require to be mixed with water directly
into the bowl. Concentrated fruit juices which need to be mixed with water with a given ratio or fruit
powders to be mixed with water or yogurt to be mixed with water to obtain ayran should be mixed in a
separate container before being poured into the dispenser's bowl.

The dispenser cap should always be fully closed to prevent possible contamination of the beverage.

Tips to facilitate usage


When the beverage reaches the preset temperature level keep the dispenser running without interruption
as cooling function stops automatically by the thermostat. Mixing function will continue to work in any case.

Keep the cooling and mixing functions on during the night to maintain the flavor standard of the beverage.

Time required for the dispenser to cool the beverage depends on many variables such as the ambient
temperature and the initial temperature of the beverage

To shorten the cooling time of the beverage and to increase the efficiency of the dispenser it is
recommended to pre-cool the beverage before pouring.

Unplug the dispenser from the electrical outlet if will not be used for a long time. Keep the tap hose and the
gasket of the bowl in a dry place.
www.combisteel.com
4