CombiSteel 7065.0015 Gebrauchsanweisung Seite 10

Dismantling and installation of spray apparatus
Make sure the plastic washer is in place before
placing the parts.
Insert the Spray pump apparatus so that the
shaft passes through the hole in the center.
Tighten the butterfly nut clockwise so that the
part does not move (you can damage the part if
you squeeze too much).
Place the magnet on the shaft. Make sure that there
is no particle (e.i. lemon core) between the magnet
and the base plate.
Place the Spray hat as shown.
Replace the pipe as shown in the illustration.
If your machine is S40 i.e. 40 liter model;
make sure the extension apparatus is on.
www.combisteel.com
10