Introduction; Security Details; Installation Procedures - CombiSteel 7065.0015 Gebrauchsanweisung

Dear Customer
We thank you for choosing our product
Important
Our company is not responsible for any negative results and damages that may occur in case the security
measures mentioned in this manual are not implemented properly. In the buildings, facilities and similar places
where the appliance is to be connected, there must be an electrical installation in accordance with the local
regulations and all necessary measures should be taken to ensure the safety of human life and property.

Introduction


Do not install, operate, repair or interfere in any way, without reading the manual completely.

For proper operation of the dispenser, the room temperature must be between + 5°C and + 32°C

Use the device only to cool the specified types of beverages.

Personnel responsible for daily operations must be carefully trained on procedures related to cleaning,
dismantling, assembly and operations in order to avoid unwanted results.

Security details


Dispenser should be connected to a grounded electricity outlet as specified in current regulations, do not
use an extension cord.

Do not connect the dispenser to an electricity outlet other than with the specified supply voltage of 230-
240V NPE- / 50HZ.

If the electric cable is damaged, it must be replaced by a manufacturer's authorized service or by a similarly
qualified person.

Disconnect the appliance from the mains before any intervention.

Dispenser is not suitable for outdoor use

Dispenser should be installed upright.

Bottom compartment with electrically operated internal parts should never be washed with water.

Dispenser should not be operated by children or used as a toy.

Do not use the device other than for its intended use.

Make sure the dispenser is not placed and does not operate under direct sunlight.

Installation procedures


Remove the device from the transport box and save the box for later use.

Check for damage occurred during transportation. If damaged please contact the forwarder.

For in case your dispenser has not been kept straight during shipping, keep it upright for at least one hour
before starting the installation procedures.

Connect the dispenser to the mains so that the cable is easily accessible.

Place the dispenser onto a surface that can hold the total weight of the dispenser and the beverage.

Place the dispenser on a dry and flat surface. Make sure there is enough space of minimum 15 cm on each
side for proper air circulation.

There should not be any heat generating source near the dispenser as it might affect the cooling
performance as well as melting of plastic components.

You can adjust the height with the adjustable feet under the dispenser.

Dispenser is not delivered pre-sterilized.

The dispenser has to be disassembled, cleaned and sterilized according to details specified in paragraph 6
before the initial use.
www.combisteel.com
3