Appliance Description; Before First Use; Preparing Milk Foam - Inventum CMK430 Gebrauchsanleitung

2

appliance description

1. Lid with sealing ring
2. Handle
3. Controllight
4. Start button for heating and frothing
5. Base
6. Maximum indication for heating milk ­ MAX
7. Maximum indication for frothing milk ­ MAX
8. Whisk with mixer
3

before first use

Before you use the appliance for the first time, please do as follows: Carefully unpack the appliance and remove all the packaging
material. Keep the material (plastic bags and cardboard) out of reach of children. Check the appliance after unpacking for any visible
damage, possible from transportation. Place the appliance on a stable and heat resistant surface.
Clean the lid, the whisk and the mixer with warm soapy water. Dry the parts thoroughly. Make sure that the parts are completely dry.
Wipe the exterior and interior with a soft damp cloth and dry thoroughly. The appliance is only suitable heating and frothing milk.
Never fill the appliance with other drinks.
4

preparing milk foam

Check that the voltage in your home corresponds with the voltage printed on the bottom of the appliance and plug the appliance in.
Lift the lid and fit the whisk in the jug. Fill the desired amount of milk into the jug. Do not exceed the maximum of the lower max. mark ­
MAX ­ 150 ml. Frothed milk expands and causes the pitcher to overflow, if filled up too high. The minimum capacity is 80 ml.
Put the lid back on the jug and place the appliance on the base. Start the preparation by pushing the button. The control light will burn
and the whisk will start turning. Depending on the filling volume, the preparation stops automatically after ca. 90 seconds. The control
light goes out to indicate the milk frother is ready.
After the preparation is completed, remove the lid upwards and pour or ladle the milk foam into a cup or bowl. Do not remove the
foam with a spoon or other metal object. This will damage the coating.
After having used the frother, clean the appliance as described in the chapter Cleaning & Maintenance.
Allow the appliance to cool down for 2 minutes before using it again or rinse it with cold water. The milk frother will be faster ready to
use it again.
TIPPS
• The best result is achievement when using whole milk.
• If the amount of milk of too low the result will not be good ­ less than 80 ml.
• The quality of the milk foam can vary between different brands of milk. If necessary, experiment with other brands of milk for a
better result.
10
• English
6
7
8
1
2
3 & 4
5