Heating Milk; Cleaning & Maintenance - Inventum CMK430 Gebrauchsanleitung

5

heating milk

Detach the whisk (spring) from the mixer and use only the black part for heating milk. Lift the lid and fit the mixer in the jug. Fill the
desired amount of milk into the jug. Do not exceed the maximum of the top max. mark ­ MAX
Put the lid back on the jug and place the appliance on the base. Start the preparation by pushing the start button. The control light will
burn and the mixer will start turning. Depending on the filling volume, the preparation stops automatically after 100 to 120 seconds.
The control light goes out to indicate the milk frother is ready.
After the preparation is completed, remove the lid upwards and pour the hot milk into a cup. After having used the appliance, clean it
as described in the chapter Cleaning & Maintenance.
Allow the appliance to cool down for 2 minutes before using it again or rinse it with cold water. The milk frother will be faster ready to
use it again.
6
cleaning & maintenance
Before cleaning always unplug the appliance and let it cool down completely. Clean the appliance immediately after every use.
Remove the whisk or the mixer by pulling it straight upwards. Clean the lid, the whisk and the mixer with warm soapy water. Dry the
parts thoroughly. Rinse the inside of the milk frother with hot water. Never use any aggressive or abrasives cleaning agents or sharp
objects that could damage the coating! Dry with a soft cloth. Make sure you remove all the milk residue from the inside. It is not
hygienic and can be harmful.
Never immerse the appliance, the power base, the power cord or plug in water or other liquids. Wipe the outside of the appliance with
a damp cloth regularly.
­ 300 ml.
English
11
•