Vitek VT-3414 W Betriebsanweisung Seite 5

• Insert the whisk (9) into the gear (8).
• Insert the whisk gear (8) into the motor unit
(2), and turn it counterclockwise until bump-
ing.
•
Insert the power plug into the mains socket.
•
Put the whisk (9) into the bowl with products.
•
To switch the blender on, press and hold the
button (4). Use this operation mode for mixing
liquid products.
• If you press and hold the button (3), the unit
will operate at maximum rotation speed.
• After you finish using the unit, take the power
plug out of the socket, disconnect the whisk
(9) from the gear (8) and disconnect the gear
(8) from the motor unit (2) turning it clock-
wise.
Attention!
Do not use the whisk (9) to make tight
–
dough.
Products should be put into the bowl
–
before the unit is switched on.
USING THE MINI CHOPPER
The chopper is used to chop meat, cheese,
onion, herbs, walnuts, almond, vegetables and
fruit.
Attention!
Do not chop very solid products, such as nut-
megs, coffee beans, cereals and ice.
Before you start chopping
Cut meat, cheese, onion, vegetables and fruit
–
into cubes approximately 2x2 cm in size.
Remove stems of herbs, peel the nuts.
–
Remove bones, sinews and cartilage from
–
meat.
To achieve the best results refer to the table
–
below.
Product type Weight, g.
Onion (cut
into several 60
pieces)
Soft fruit 100
Garlic 50
Bread
15
(dried toast)
Cheese
Nuts
Eggs
Meat
Chopping
Caution: the knife is very sharp! Always hold
the knife by the upper plastic end.
•
•
•
Note:
–
–
–
–
–
–
–
–
–
–
–
–
–
Approximate
cooking time,
seconds
Attention!
4-8
Strictly follow the described sequence of
operations.
10
CLEANING
Attention! The blades of the chopping knife
4-8
(6) are very sharp and dangerous. Handle the
chopping knife (6) very carefully!
12
1.
5
ENGLISH
30
30
80
80
Place the chopper bowl (5) on a flat stable
surface.
Set the chopping knife (6) on the axis of chop-
per bowl (5).
Put the products into the chopper bowl (5).
Do not switch the unit on when the chopper
bowl (5) is empty.
Put the lid (7) on the chopper bowl (5).
Install the motor unit (2) on the geared lid (7)
and rotate it clockwise until it is fixed.
To connect the unit to the mains, insert the
power cord plug into the mains socket.
To switch the blender on, press and hold the
button (4).
When the button (3) is pressed, the knife
rotates at maximal rotation speed.
During operation hold the motor unit (2) with
one hand and the chopper bowl (5) with the
other hand.
After using the unit, wait till the chopping knife
(6) fully stops.
Unplug the unit.
After using the chopper disconnect the motor
unit (2) from the geared lid (7).
Remove the geared lid (7).
Carefully remove the chopping knife (6) taking
it by the upper plastic end.
Take the chopped products out of the chop-
per bowl (5).
Unplug the unit before cleaning.
12
12
8
8-12