Black&Decker KA300 Übersetzung Der Originalanleitung Seite 6

ENGLISH
used in a preliminary assessment of exposure.
Warning! The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which
the tool is used. The vibration level may increase
above the level stated.
When assessing vibration exposure to determine
safety measures required by 2002/44/EC to
protect persons regularly using power tools in
employment, an estimation of vibration exposure
should consider, the actual conditions of use and
the way the tool is used, including taking account
of all parts of the operating cycle such as the
times when the tool is switched off and when it is
running idle in addition to the trigger time.
Labels on tool
The following pictograms are shown on the tool:
Warning! To reduce the risk of injury, the
user must read the instruction manual.
Electrical safety
This tool is double insulated therefore
no earth wire is required. Always check
that the power supply corresponds to the
voltage on the rating plate.
• If the supply cord is damaged, it must be
replaced by the manufacturer or an authorised
Black & Decker Service Centre in order to
avoid a hazard.
Using an extension cable
• Always use an approved extension cable
suitable for the power input of this tool (see
technical data). Before use, inspect the
extension cable for signs of damage, wear
and ageing. Replace the extension cable if
damaged or defective. When using a cable
reel, always unwind the cable completely.
Use of an extension cable not suitable for the
power input of the tool or which is damaged
or defective may result in a risk of fi re and
electric shock.
Features
1. On/off switch
2. Dust extraction outlet
3. Paper clamp lever
4. Sanding base
Assembly
Warning! Before assembly, make sure that the
tool is switched off and unplugged.
6
Fitting sanding sheets (fi g. A)
Warning! Never use the tool without a sanding
sheet or accessory in place.
Fitting regular sanding sheets (fi g. A)
Warning! Make sure that the tool is switched off
and unplugged.
• Soften the sanding sheet by rubbing its non-
abrasive side over the edge of a worktop.
• Press the paper clamp levers (3) upwards to
release them from the retaining grooves and
open the paper clamps (3) by pressing them
down.
• Place the sheet onto the sanding base (4).
• Insert the edge of the sanding sheet into the
front paper clamp (3) as shown.
• Press the front paper clamp lever (3)
downwards and locate it in the retaining
groove.
• While keeping a slight tension on the sheet,
insert the rear edge of the sheet into the rear
paper clamp (3).
• Press the rear paper clamp lever (3)
downwards and locate it in the retaining
groove.
Connecting a vacuum cleaner (fi g. C)
• Insert the adaptor (5) into the dust extraction
outlet (2).
• Connect the hose (6) of the vacuum cleaner to
the adaptor (5).
Residual risks
Additional residual risks may arise when using the
tool which may not be included in the enclosed
safety warnings. These risks can arise from
misuse, prolonged use etc.
Even with the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks cannot be avoided.
These include:
• Injuries caused by touching any rotating/
moving parts.
• Injuries caused when changing any parts,
blades or accessories.
• Injuries caused by prolonged use of a tool.
When using any tool for prolonged periods
make sure you také regular breaks.
• Impairment of hearing.
• Health hazards caused by breathing dust
developer when using your tool (example:-
working with wood, especially oak, beech and
MDF).