Ingersoll-Rand BC20 Technische Produktdaten Seite 3

Instructions for Charging Battery
Do not charge battery pack when temperature is below 32°F (0°C) or above 104°F (40°C).
Completely charge new battery packs before using.
Charging time is approximately 60 minutes.
Action
Plug charger
into 100-240V
Power On (Stand-By).
AC power
outlet.
Charging.
Insert battery
pack into Fuel gage will indicate state of charge.
charger
Renew Cycle Recommended.
and twist
clockwise.
Renew Cycle Active.
Communications Failure.
Reinsert battery.
Initial Temperature.
Charging paused until battery has
returned to safe temperature.
Time Out.
Charge time exceeded. Battery may
be defective.
In Cycle Temperature.
Charging paused until battery has
returned to safe temperature.
Over Voltage.
High voltage detected. Battery may
be defective.
Over Current.
High current detected. Battery may
be defective.
19.2V NiCd Battery Inserted
BC20 is not compatible with 19.2V
NiCd batteries.
Remove
battery pack. Charge Completed.
Legend:
ä Flash l On m Off
Renew Cycle
Renew indicator will illuminate when charger has detected a decrease in battery capacity. It is
not required to run Renew cycle, but running it may increase capacity of battery. Press Renew
button to initiate Renew Cycle which may take up to 24 hours to complete. Renew Cycle will
recalibrate fuel gage in battery.
47084330_ed2
Condition
Charger Display
Alarm
(Sound)
Green Red Blue
l m m
l m m
l m l
l m
ä
Low ♪ mmmm
m l m
Low ♪ mmmm
2 x ä
m m
Low ♪ mmmm
3 x ä
m m
Low ♪ mmmm
4 x ä
m m
Low ♪ mmmm
5 x ä
m m
Low ♪ mmmm
6 x ä
m m
Low ♪ mmmm
7 x ä
m m
l m m
EN
Fuel
Guage
-
mmmm
ämmm
-
Ê
ämmm
-
Ê
-
mmmm
High
llll
♪ ♪ ♪
EN-2