Herunterladen Inhalt Inhalt Diese Seite drucken

Grex G6.2 Sicherheit Und Gebrauchsanleitung Seite 12

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

G6.
2
1.5 Widen the visor and fasten the other side of the Pinlock
pin (Fig.9).
1.6 Release the visor.
1.7 Remove the protective film from the Pinlock
silicone-sealed profile of the inner visor adheres to the visor.
1.8 Fit the visor in the helmet.
2
CHECKING AND ADJUSTING THE INNER VISOR STRETCHING
Check the correct system assembly by opening and closing the visor. Check that both
visors are correctly fastened and do not move.
If the inner visor is not tightly fixed to the visor, move the external adjustment levers
simultaneously upwards to increase the stretch (Fig. 10). This operation must be carried
out gradually.
The maximum stretch is achieved when the pin adjustment external levers are turned
outwards.
WARNING
The presence of dust between the two visors may produce scratches on both surfaces.
Scratched visors and inner visors may cause reduced visibility and must therefore be
replaced.
Regularly check the correct stretching of the inner visor to prevent the same from mov-
ing and scratching both surfaces.
If the helmet visor fogs up and/or condensation forms between the visors, check both
for system correct assembly and stretching.
An excessive and early stretch of the inner visor may result in excessive adherence
against visor surface and/or permanent deformations with subsequent inability to per-
form following adjustments correctly.
The extended use under special weather conditions may reduce system performance
and result in partial fogging and problems of condensation on the inner visor. In this
case, remove the inner visor from the helmet visor and dry it with dry and lukewarm air
to restore system efficiency.
Intense sweating /breathing, the use under particular weather conditions (low temper-
atures, and/or high humidity and/or sudden changes in temperature or heavy rain) and
intense and prolonged use may affect the performance of the system and cause the
fogging or formation of condensation on the inner visor. In such cases, after using the
helmet and to restore the system efficiency, remove the inner visor from the helmet
visor and let it dry with dry and lukewarm air. The same procedure must be applied to
the helmet, in order to dry out humidity in case it has formed up as a consequence of
the conditions described above.
3
PINLOCK
INNER VISOR DISASSEMBLY
®
3.1 Remove the visor equipped with Pinlock
3.2 Widen the visor and release the Pinlock
3.3 Release the visor.
12
INSTRUCTIONS FOR USE
inner visor to the second
®
inner visor and check that the entire
®
inner visor.
®
inner visor from the pins (Fig. 9).
®

Werbung

Inhaltsverzeichnis
loading

Verwandte Produkte für Grex G6.2

Inhaltsverzeichnis