Grex G6.2 Sicherheit Und Gebrauchsanleitung Seite 10

G6.
2
VISOR
1 DISASSEMBLY
1.1 Open the visor completely.
1.2 Press and hold the visor release button (A) down and slide the visor forward until
it clicks (Fig. 1).
1.3 Free the visor hooks (B1 and B2) from their housing.
1.4 Follow the same steps on the other side of the helmet.
Warning: do not remove the visor mechanisms from the shell.
2 ASSEMBLY
2.1 Set the visor in open position by placing the visor hooks (B1 and B2) in line with
the housings in the visor mechanism (Fig. 2).
2.2 Insert hook B1 in the housing provided and press the visor against the shell in line
with hook B2. This will actuate the visor release button (Fig. 2).
2.3 Slide the visor until the visor locks into place.
2.4 Follow the same steps on the other side of the helmet.
WARNING
- After each assembly or disassembly procedure of the different parts, check that
the visor mechanism works properly by pulling the visor up and down; if neces-
sary, repeat the above described steps.
- If the visor pulling-up/-down mechanisms get damaged or malfunction, refer to a
Nolangroup authorized dealer.
REMOVABLE INNER COMFORT PADDING
(Only for versions with removable inner padding)
1 DISASSEMBLY OF THE CHEEK PAD
1.1 Unfasten the chin strap (see instructions).
1.2 Take hold of the rear part of the left cheek pad and pull towards the inside of the
helmet to undo the snap fastener (Fig. 3).
1.3 Release the flap near the internal chin guard (Fig. 4).
1.4 Repeat the previous operations for the right cheek pad.
2 LINER FITTING
2.1 Unhook the left rear flap from the support fixed to the inner shell by slightly de-
forming the shell sealing edge and slightly pulling the comfort padding in the hel-
met neck-ring area towards the inside (Fig. 5). Follow the same steps to remove
the central and right rear flap.
2.2 Unhook the left front flap from the support fixed to the inner shell by slightly puling
the comfort padding towards the inside of the helmet (Fig. 6).
Follow the same steps to remove the central and right front flap.
2.3 Remove the inner comfort padding from the helmet.
10
INSTRUCTIONS FOR USE