Herunterladen Inhalt Inhalt Diese Seite drucken

Grex G6.2 Sicherheit Und Gebrauchsanleitung Seite 11

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

3
ASSEMBLY LINER
3.1 Properly insert the comfort padding into the helmet.
3.2 Hook the front fastening flaps to the support fixed to the inner shell by slightly
pushing the liner towards the outside of the helmet (Fig. 6).
3.3 Hook the rear fastening flaps of the inner comfort padding to the seats in the hel-
met neck-ring area (Fig. 5). To carry out this step, slightly deform the sealing edge
of the shell and push until the fastenings click. Take care to stretch the liner so that
it adheres to the inner polystyrene
4
CHEEK PAD FITTING
4.1 Insert the chin strap into the appropriate space on the cheek pad; insert the flap
on the front of the cheek pad into the seat of the inner chin guard (Fig. 3 and 4).
4.2 At the same time insert the cheek pad fastening button into liner eyelet and hook
it to the EPS support (Fig. 7).
4.3 Repeat the previous operations for the right cheek pad.
WARNING
-
If your helmet is equipped with the D-Ring retention system, pull it down as
indicated in the attached D-Ring label.
-
After each removal or restoring of the comfort padding, check the comfort by
wearing the helmet and, if necessary, repeat the steps described above.
-
Remove the padding only when cleaning or washing is required.
-
Never use the helmet if the inner comfort padding and the cheek pads have not
been correctly and completely fitted.
-
Delicately hand-wash in lukewarm water (max. 30°C) and neutral soap.
-
Rinse with cold water and allow drying at room temperature, away from direct
sunlight.
-
The inner polystyrene is an easily deformable material. It is apt to change or get
partially destroyed to help absorb shocks.
-
Clean it with a wet cloth and allow it to dry at room temperature away from direct
sunlight.
-
Do not modify or alter the helmet's internal polystyrene components in any way.
-
Never machine-wash the inner comfort padding.
-
Never use tools or equipment of any sort to carry out the steps described above
(Available as standard or optional accessory)
1
PINLOCK
INNER VISOR ASSEMBLY
®
1.1 Remove the visor.
1.2 Make sure that the inner surface of the visor is clean and check that the pin adjust-
ment external levers are turned inwards.
1.3 Place the Pinlock
the silicone-sealed profile of the Pinlock
the inner surface of the visor.
1.4 Insert one side of the Pinlock
position (Fig.8).
inner visor on the visor.
®
inner visor on one of the visor pins and hold it in
®
inner visor should be in contact with
®
INSTRUCTIONS FOR USE
G6.
2
11

Werbung

Inhaltsverzeichnis
loading

Verwandte Produkte für Grex G6.2

Inhaltsverzeichnis