HP Latex 115 Einführende Informationen Seite 13

Error code
21.2:10
21.5:03
25.n:10 (where n = the
ink cartridge number)
27.1:00
27.n:01 (where n = the
printhead slot number)
29:00
29:01
29.1:01
29.2:00
32:01
ENWW
Recommendation
Maintenance cartridge error.
1. Turn off the printer.
2. Remove and reinsert the maintenance cartridge.
3. Turn on the printer.
4. If the error persists, replace the maintenance cartridge.
The part that advances the printhead maintenance cartridge web wipe is blocked.
1. Turn off the printer.
2. Remove and reinsert the maintenance cartridge.
3. Turn on the printer.
4. If the error persists, replace the maintenance cartridge.
A possible error in the ink cartridge pressure sensor has been detected. The ink level
reported may not be accurate. Call your service representative if feasible.
Several blocked nozzles have been detected in the optimizer printhead. If print
quality is not acceptable, clean or replace the printhead.
A large number of blocked nozzles have been detected in one or more printheads.
Calibration may have failed due to low printhead performance. Clean all the
printheads and check their status.
The maintenance cartridge (part number CZ681A) is almost full. It will need to be
replaced soon.
The maintenance cartridge is not inserted correctly.
1. Open the maintenance cartridge door on the right of the printer.
2. Make sure that the maintenance cartridge is correctly seated, then close the
door.
3. If the error persists, replace the maintenance cartridge.
Unable to track the maintenance cartridge status. Check, visually, that the
maintenance cartridge has a correct status pattern on it.
Unable to advance the printhead cleaning roll. Replace the maintenance cartridge.
The take-up reel is disconnected. If you want to use the take-up reel, turn off the
printer and ensure that all take-up reel cables are connected (sensor cables, printer
cable). If you do not want to use it, you may need to unload the substrate manually
from the take-up reel. Remember to cut the substrate first.
Front-panel error codes
11