Introduction; Intended Use - Viatom Checkme O2 Bedienungsanleitung

1. Introduction

1.1

Intended Use

The Oxiband Wrist Pulse Oximeter is intended to be used for
measuring, displaying and storing of pulse oxygen saturation (SpO
and pulse rate in home or healthcare facilities environment.
Note:
The data and results provided by this device are for pre-check screening
purpose only and cannot be directly used for diagnostic or treatment.
The data provided by the APP is not intended for diagnosis or treatment
purpose, always consult your doctor for any health condition.
Warnings and Cautionary Advices
Do not use this device during MRI examination.

Do not use the device in a combustible environment (i.e.,

oxygen-enriched environment).
Never submerge the device in water or other liquids. Do not

clean the device with acetone or other volatile solutions.
Do not drop this device or subject it to strong impact.

Do not place this device in pressure vessels or gas sterilization

device.
Do not dismantle the device, as this could cause damage or

malfunctions or impede the operation of the device.
This device is not intended for use by people (including children)

with restricted physical, sensory or mental skills or a lack of
experience and/or a lack of knowledge, unless they are
supervised by a person who has responsibility for their safety or
they receive instructions from this person on how to use the
device.
Do not store the device in the following locations: locations in

which the device is exposed to direct sunlight, high
4
)
2