Noise/Vibration Information - Bosch Indego M 700 Originalbetriebsanleitung

Robotic Lawnmower
Input voltage (AC)
Protection class
Frequency
Output voltage (DC)
Protection type
Weight
A) Depends on cutting height, grass conditions and moisture
B) Internal battery temperature

Noise/Vibration Information

Noise emission values determined according to
EN 50636-2-107.
Typically the A-weighted noise levels of the product are:
Sound power level 61 dB(A). Uncertainty K = 2 dB.
Explanation of Figures
Action
Accessories
Delivery scope/unpacking the mower B
Laying out perimeter wire
Extending perimeter wire
Laying perimeter wire around new in-
ner object
Lifting up and carrying the mower
Setting the height of cut
SpotMow
Cleaning
Maintenance
Adding a further lawn area
– with additional docking station
(right)
– without additional docking station
(top left)
Replacing the battery
Software update
Power supply unit connection
Installation
For a video guide on how to install the mower, please visit
www.bosch-indego.com or use the following QR-Code. Al-
ternatively, follow the Installation Guide delivered with the
product.
Bosch Power Tools
SI
Unit
V
Hz
V
kg
Figure Page
Remove stones, loose pieces of wood, wire, live mains
A 423
cables and other foreign objects from the cutting area.
424
Make sure that the cutting area is even and has no ditches,
grooves and steep slopes above 15°/27 %, which are clear
C 424
obstructions for the mower.
D 425
The docking station must be positioned on the wire at an
E 425
outer edge of the cutting area. It may not be positioned on
the side of a tool or garden shed standing as an island within
F 426 the lawn to be mowed.
It is recommended that you mow your lawn once with a con-
G 426
ventional lawnmower before installing and before the first
H 427
mowing of the new season and whenever the grass clippings
I 428
would be longer than 5 mm.
J 428 The mower's cutting system is designed to cut small lengths
of grass (30–50 mm). The clippings can remain as mulch to
K 427
fertilize the lawn. The height of cut for mower can be adjus-
ted to 30, 40 and 50 mm.
It is recommended to start with a higher setting and then
gradually decrease the height of cut as the wire disappears
under the grass. This prevents your Indego from cutting the
L 429
wire.
Additional perimeter wire can be added using a wire con-
M 430−431
nector (see figures D–E).
N 432
The perimeter wire can be extended up to a maximum length
of 350 m.
The perimeter wire can be buried up to 5 cm under the
ground (or under non-metallic slabs).
To avoid causing damage to the perimeter wire, do not verti-
cut or rake the area where it is positioned.
When laying out the wire avoid angles of less than 45°. This
can affect the performance.
Indego M 700
220-240
/ II
50–60
24
IPX7
1.25
Check if the perimeter wire is fully pegged to
the ground avoiding any slack lengths of wire.
Any loose wire can be a trip hazard.
F 016 L81 885 | (23.10.2019)
English | 25
Indego M+ 700
220-240
/ II
50–60
24
IPX7
1.25