Cleaning And Maintenance; Disposal - Powerfix Profi HG00962A Bedienungs- Und Sicherheitshinweise

Failure
Five digits flash
simultaneously
every second.
The LCD
display 5
does not
continue to
count.
Nothing is
displayed
on the LCD
display 5 .
˜ Cleaning and maintenance
Clean the calliper before and after using it with a dry cloth;
never use petrol, solvents or cleaning agents.
Do not immerse the calliper into water. Liquids can damage
the calliper.
Always switch the LCD display 5 off when not using the
calliper. This will extend the life of the battery.
Keep away from electrical current and electrically charged
pens to prevent damage to the chip.
˜ Disposal
The packaging is made entirely of recyclable materials, which
you may dispose of at local recycling facilities. The Green Dot
is not valid for Germany.
Observe the marking of the packaging materials for
waste separation, which are marked with
abbreviations (a) and numbers (b) with following
meaning: 1–7: plastics / 20–22: paper and
fibreboard / 80–98: composite materials.
The product and packaging materials are recyclable,
dispose of it separately for better waste treatment.
The Triman logo is valid in France only.
12 GB
Cause
The battery
voltage is lower
than 2.7 V.
Faulty wiring or
circuit.
1. LCD
display 5 is
switched off.
2. Battery is the
wrong way
round or
the battery
contact is
poor.
3. The battery
voltage is
lower than
2.1 V.
Solution
Replace the battery in
line with the chapter on
"Inserting / replacing
battery".
Remove battery
and re-insert after
30 seconds.
1. Switch the LCD
display 5 on by
pressing the ON /
OFF key 10.
2. Remove the battery
and insert / replace
it in line with
the terminals
and the chapter
"Inserting / replacing
the battery" so
that it touches all
contacts.
3. Replace the
battery in line
with the chapter
"Inserting / replacing
the battery".