Connections, Control And Display Elements; Power On/Off - Palmer STUDIMON 5 Bedienungsanleitung

CONNECTIONS, CONTROL AND DISPLAY ELEMENTS

5
2
1
POWER SOCKET AND FUSE HOLDER
1
IEC power socket with integrated fuse holder. A suitable power cable is included in delivery.
IMPORTANT NOTE: Only replace the fuse with a fuse of the same type. Please note the inscription on the
housing. If a fuse trips repeatedly, please contact an authorized service center.
POWER ON / OFF
2
On / off switch for the device power supply. The studio monitor should always be the last device to be
switched on in the signal chain, and the first to be switched off.
INPUT XLR
3
Balanced line input with female 3-pin XLR jack. Both input jacks are wired in parallel. Do not use both input
jacks at the same time.
INPUT TRS (Tip - Ring - Sleeve)
4
Balanced line input with 6.35 mm jack. Both input jacks are wired in parallel. Do not use both input jacks at
the same time.
VOLUME MIN - MAX
5
Turn the volume control counterclockwise to turn down the volume, and clockwise to turn it up. Set the left and
right monitors to the same volume level to achieve homogeneous stereo sound.
BASS REFLEX OPENING
6
Do not place any items in the bass reflex opening, do not place items directly behind the bass reflex open-
ing and do not cover the opening. Failure to observe these rules can lead to altered sound dispersion and
cause undesired noise.
6
6
4
3
8
9
7