Philips FC6161 Bedienungsanleitung Seite 21

Problem
Dust escapes from the
vacuum cleaner.
The vacuum cleaner does
not work properly when
one of the accessories
is attached to the
small nozzle.
The 'brush blocked' light
flashes red.
The appliance produces a
lot of noise.
The appliance does not
pick up dirt effectively.
Solution
The dust compartment may be full. Empty the dust compartment.
The dust compartment may not be attached to the appliance properly.
Attach the dust compartment to the appliance properly.
Perhaps the filter unit is not placed in the dust compartment properly.
Place the filter unit in the dust compartment properly.
The dust compartment may be full. Empty the dust compartment.
The accessory may be clogged. Remove the obstruction from the
accessory.
The filter unit may be clogged. Clean the inner filter and the outer filter
(see chapter 'Cleaning').
The roller brush is blocked. Clean the roller brush (see chapter 'Cleaning').
If you use the stick unit on soft, deep-pile carpet, the 'brush blocked' light
may also start to flash red, even though the roller brush is not blocked. In
this case, the suction power does not decrease and you can continue to
use the stick unit.
There are solid parts inside the dust compartment. Empty the dust
compartment and clean the filter unit (see chapter 'Cleaning').
The floor nozzle joint may be clogged. Clean the floor nozzle joint (see
chapter 'Cleaning').
The roller brush is clogged. Clean the roller brush (see chapter 'Cleaning').
English
21