Tracker Maxima Bedienungsanleitung Seite 28

EN
3.
Now your Maxima should be producing some static noise because it is receiving
too much strong signal. When this occurs, turn down the signal strength by
turning the gain wheel counter-clockwise. If the transmitter is placed near
Maxima receiver, 0 to 1 is enough. You will notice the noise slowly turning into a
louder beep sound. This means the receiver is picking up the transmitter.
4.
Now press ▲ or ▼ to adjust the four digit
number to find the correct frequency channel.
You should be able to maintain 2-3 bars on the
gain signal and hear a clean crisp "beep" pulse.
This indicates the receiver and the transmitter
are tuned correctly.
5.
Press ENTER. The device will ask you to
choose a memory location to store the data.
Press ▲ or ▼ to switch between memory
location. Find an unused channel and press
ENTER. Please note that choosing an existing
channel will cause the device to overwrite with
new data.
Congratulations! You have now sucessfully saved a frequency to your receiver!
Removing a channel
1.
Press ▲ or ▼ button to choose a channel you want removed.
2.
Press MODE button. Confirm if it is the correct channel.
3.
Press ▼ button twice until you see the 4 digit number turning into ----.
4.
Press ENTER twice. The selected channel is now removed from Maxima's
memory slot.
Changing the receiver's battery
The receiver has a low battery indicator, which is lit when the battery is low. Open up
the battery cover behind the receiver and replace with new battery or batteries.
Ver 1.1
28
Copyright © 2008 Tracker Oy. All rights reserved.