Extremis ARTHUR Bedienungsanleitung Seite 5

6. There are 4 axes per table leg. For the table of 8 persons,
there are only 3 small axes per leg.
8. Repeat this step until you have used all the plates and
have obtained a full circle. Make sure that all the table
segments are aligned the same way.
10. Then put the large round tabletop onto the assembly.
Position the disk on top of the plastic wheels so that
they fit nto the groove in the bottom of the disk. Now
the disk will swivel smoothly.
7. Slide the first table segment into place horizontally.
The already fitted axes will fit perfectly in the grooves
on both sides of the table segment.
9. Position all the wheeled aluminium blocks. Do not
tighten every segment with its block separately, but
only when you have assembled all the segments. Do
not start tightening the screws before all the table
segments are in place.
Continue tightening until all the blocks are tightened.
is necessary for the table's stability.
11. Finally unscrew the rubber feet until maximum
contact with the surface This will have a stabilising
effect.
EXTREMELY IMPORTANT
english
:
5