Herunterladen Inhalt Inhalt Diese Seite drucken

Philips 1200 Serie Benutzerhandbuch Seite 19

Vorschau ausblenden Andere Handbücher für 1200 Serie:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 39
Problem
The coffee is not hot
enough.
 
Coffee does not come
out or coffee comes out
slowly.
 
 
Cause
The machine is performing its
self-adjustment procedure. This
procedure is started
automatically when you use the
machine for the first time, when
you change to another type of
coffee beans or after a long
period of non-use.
The grinder is set to a too
coarse setting.
The temperature is set too low.
A cold cup reduces the
temperature of the drink.
Adding milk reduces the
temperature of the drink.
The AquaClean water filter was
not prepared properly for
installation.
The AquaClean water filter is
clogged.
The grinder is set to a too fine
setting.
The brew group is dirty.
The coffee dispensing spout is
dirty.
Solution
Brew 5 cups of coffee initially to allow
the machine to complete its self-
adjustment procedure.
Set the grinder to a finer (lower) setting.
Brew 2 to 3 drinks to be able to before
taste the full difference.
Set the temperature to the maximum
(see 'Adjusting the coffee temperature').
Preheat the cups by rinsing them with
hot water.
Regardless of whether you add hot or
cold milk, adding milk always reduces
the temperature of the coffee. Preheat
the cups by rinsing them with hot water.
Remove the AquaClean water filter and
try to brew a coffee again. If this works,
make sure that you have prepared the
AquaClean water filter properly before
you place it back. See chapter
'AquaClean water filter' for step-by-step
instructions.
After a long period of non-use, you
need to prepare the AquaClean water
filter for use again and then place it
back. See step 1 - 3 of chapter
'Activating the AquaClean water filter'.
Replace the AquaClean water filter
every 3 months. A filter that is older
than 3 months can become clogged.
Set the grinder to a coarser (higher)
setting. Note that this will impact the
coffee taste.
Remove the brew group and rinse it
under the tap (see 'Cleaning the brew
group under the tap').
Clean the coffee dispensing spout and
its holes with a pipe cleaner or needle.
English
21

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis