Set Channel; Base Station; Change Display / Setting; Clock Reception - Oregon Scientific WMR100TH Bedienungsanleitung

SET CHANNEL

Set the channel by adjusting the CODE switch to one of
the following settings.
CHANNEL NUMBER
1
2
3
4
5
6
7
8
9
10
10
SWITCH SETTING
Other switch settings
(Not recommend)

BASE STATION

CHANGE DISPLAY / SETTING

To change the display and settings, use the following
buttons on the rotating dial: SELECT, MEMORY /
ON/OFF, MODE and ALARM.
TIP To exit from the setting mode, push any button.
Alternatively, the base station will automatically exit after
30 seconds.

CLOCK RECEPTION

This product is designed to synchronize its calendar
clock automatically once it is brought within range of a
radio signal:
WMR100:
• DCF-77 generated from Frankfurt, Germany for
Central Europe
• MSF-60 generated from Anthorn, England
10
In addition, the UNIT
and SEARCH buttons
located at the bottom of
the base station allows
pre-setting of the remote
sensor channels and the
measurement units for
display.