View Temperature And Humidity Area; Select Measurement Unit; Select Sensor Channel; Minimum / Maximum Records - Oregon Scientific BAR826HG Bedienungsanleitung

VIEW TEMPERATURE AND HUMIDITY AREA

Press MODE to navigate to the Temperature and
Humidity Areas.
Temperature data is given at the top; Humidity is below.

SELECT MEASUREMENT UNIT

Slide the °C / °F switch (inside the clock battery
compartment), to the setting you want.

SELECT SENSOR CHANNEL

Press CH to switch between sensors 1-5.
The house icon shows the selected remote sensor.
• To auto-scan between sensors, press and hold CH
for 2 seconds. Each sensor's data will be displayed
for 3 seconds.
P/N:086-003808-011 REV1
17/162
BAR826HG_UM_EN.P65
• To end auto-scan, press CH or MEM with the
Temperature / Humidity Area selected.
NOTE
temperature data, the humidity will not be shown.

MINIMUM / MAXIMUM RECORDS

• Press MEM repeatedly to view current, maximum
and minimum records for the selected sensor.
• To clear the records, press and hold MEM for 2
seconds. A beep will sound to confirm that the
memory has been cleared.
TEMP, HUMIDITY & PRESSURE TREND
TREND
TEMPERATURE
HUMIDITY
PRESSURE
16
16
If you select a sensor that collects only
RISING STEADY FALLING
2005.3.8, 11:21 AM