Yedoo Fifty Einleitung Seite 11

the riding, it starts to "crack" in the spokes, it is necessary to tighten the wires of the wheels
equally by 2 turns (we recommend to entrust a professional service with it), eventually to
grease, adjust or change the bearings and bearings parts. If the change of wheels is necessary,
use always wheels/tyres of the same parameters according to the original ones. Carry out
the disassembly in a contrary way than the assembly (see Operating Instructions). Entrust
the exchange or repair of a tyre and inner tube to a professional service. If the construction
of the device for taking off contains self-locking nuts or other self-locking accessories, when
unloosing and tightening them frequently, they lose their effi ciency. In this case it is necessary
to substitute the work parts.
SECURITY MEASURE
Before the assembly, read the operating instructions carefully. The device for taking off has a
loading limit of 75 kg. Control all screws and tightening of nuts. To drive securely, use always
a headpiece, knee protectors, elbow protectors, wrist protectors and solid shoes. The device
for taking off is not designed for riding on ground communications in a road traffi c and for
riding when it is dark. Do not use it when it is raining, on a humid slipping surface, on gravel
and snow. Control the screw connections, tightening mechanisms and brake/s regularly to
avoid an eventual accident when riding. We do not recommend to carry out adaptations of
this device for taking off for other models. Do not brake too rapidly and suddenly – you could
fall down. The manufacturer does not guarantee the damnifi cation or damage that may arise
when using this product. The device for taking off is designed only for 1 rider – co-riders are
forbidden!
WARNING:
Mechanisms for decreasing the speed (brake lining, rims, tyres etc.) are becoming
warm during the use and it is, therefore, not convenient to touch them after the braking.
WHILE RIDING SCOOTER USE AVAILABLE PROTECTIVE
EQUIPMENT (HELMET, PROTECTIVE GLOVES ETC.).
GUARANTEE LIMITATION
The guarantee does not apply to a damage or loss of a respective part caused by a fall, abra-
sion, incorrect assembly, non-adequate adaptation, jumping, acrobatic riding, headless riding,
competition riding, rough treatment, neglecting usual maintenance or using the device for
taking off completed by any motor appliance.
The manufacturer reserves the right for changes of the operating instructions in the course of
the products development.
The product fulfi ls the requirements of the norm ČSN EN 71-1.
Producer and importer to the EU: Intrea-Piko, s. r. o., Praha
10
|