Peaq PMS200BT Bedienungsanleitung Seite 38

ENGLISH
STANDBY
To turn the product back into standby mode,
press on the remote control or on the
touch panel.
NOTE: During standby mode,
will be displayed on the touch panel.
ANTENNA
Try different positions of the antenna to figure
out the best reception position.
VOLUME
Adjust the volume with the volume knob or
on the remote control.
38
PMS200BT_A5_131031_1.indb 38
MODE
Press MODE to select the following modes:
– CD
– USB
– CARD
CLOCK SETUP
1. During standby mode, press and hold
MEMORY on the remote control.
2. 24-HOUR (or 12-HOUR) starts flashing
on the screen. Press
indicator
the 24/12 hour format and confirm by
pressing MEMORY.
3. The hour digits AM (or PM) start flashing.
Press
confirm by pressing MEMORY.
4. The minute digits start flashing. Press
or
firm by pressing MEMORY.
5. Now the time is set.
NOTE: Time setup can also be adjusted on
the touch panel.
TIMER
1. After the time is set, press TIMER on the
remote control for few seconds.
2. ON indicator will be displayed on the
screen and hour digits start flashing.
Press
confirm by pressing TIMER.
3. The minute digits start flashing. Press
or
firm by pressing TIMER.
– BT LINK
– AUX
– TUNER
or to adjust
or to adjust the hour and
to adjust the minute and con-
or to adjust the hour and
to adjust the minute and con-
31/10/13 2:54 PM