EWT Clima 15TLS Bedienungsanleitung Seite 6

Packaging
• After unpacking the appliance, check the same for transport damage and
the contents for completeness! In the event of damage or an incomplete
delivery, contact your authorised retailer!
• Do not discard the original box! It can be used for storage and dispatch
to avoid transport damage!
• Dispose of the packaging material in a proper manner! Plastic bags
should be kept away from children!
Location
• The appliance should be placed with a minimum distance of 50 cm from
flammable objects, walls or other structures! The appliance openings
must not be obstructed in any way!
• Do not place the appliance on instable surfaces (e.g. a bed), where it
can tip over!
• The appliance must not be located below a socket outlet!
Power Cord
• Only use an approved extension cord that is suitable for the appliance
rating!
• Position the power cord so that it does not pose a tripping hazard and
possibly cause the appliance to be knocked over.
• The power cord must not come into contact with hot appliance parts!
• Never pull the plug out of the socket at the cord!
• Never move the appliance by pulling at the cord or use the cord for
carrying purposes!
• Do not coil the cord around the appliance! Do not use the appliance
with the cord coiled!
Start Up
• After switching on the appliance for the first time and after an extended
period of non-use, a smell may be noticed for a short time.
• To use, insert the plug in the socket.
Attention! When using the appliance free-standing, the feet and castors
if provided must be fitted prior to use, see pict. 3.
Fitting Feet & Castors see pict. 3
(Exception Clima 10TLS & ECL supplied with feet but no castors)
Switch (S) see pict. 4-5
With the switch (S) the power setting can be selected.
Thermostat (T) see pict. 4-6
In order to maintain a certain room temperature, set the controller to
"max.". Operate the appliance at full power until the required room
temperature is reached. Set back the thermostatic controller until the
appliance switches off with an audible "click". This temperature will be
kept almost constant by the thermostatic control switching on and off
automatically. Please note that the appliance can only be switched on
when the thermostat setting is higher then the room temperature.
Transport see pict. 2
The appliance is provided with a handle for easy carrying.
Frost protection see pict. 6
• Set the controller (T) to  and the controller (S) to required the heating
output.
• When the temperature falls below +5 °C ... +8 °C, the appliance switches
on automatically.
Overheat cut-out
The built-in overheat cut-out switches off the appliance automatically
in the event of a fault! Switch off the appliance (set switch to "0" and
thermostat to ) or disconnect the mains plug from the socket. After a
short cooling down phase, the appliance is ready for use again! If the
fault should occur again, see your local dealer!
CAUTION: In order to avoid a hazard due to inadvertent resetting of the
thermal cut-out, this appliance must not be supplied through an external
switching device, such as a timer, or connected to a circuit that is regularly
switching on and off by the utility.
Cleaning
• Switch off the appliance first and disconnect the plug from the socket!
• Clean the housing with a moist cloth, vacuum cleaner or brush.
• Do not use any abrasive or caustic cleaning agents!
• Do not use any flammable cleaning agents e.g. petrol or spirit for
cleaning the appliance.
• Never immerse the appliance in water! Danger to life!
• If the appliance is not used for extended periods, it must be protected
against excessive dust and dirt.
• The outlet grille may become discoloured with use. This is caused by
airborne pollution and is not a fault.
Disposal
• Old appliances should be taken to a public refuse collection point for
proper disposal!
• Worn out appliances must be made unusable by cutting through the
power cord.
After sales service
All repairs must be referred to authorised personnel!
See your local dealer. Any tampering with the appliance will invalidate
the warranty.
Repairs carried out improperly and by unqualified persons may
have serious consequences for the user!
In the interests of further development, the appliance may be subject
to constructional or design changes without prior notice.