Replacing The Rechargeable Battery - Silvercrest SAK 4000 A1 Bedienungs- Und Sicherheitshinweise

Using the USB cable
device or a USB device. The LED charge display
up red during charging, and the notice
touch display
5
is switched on during the charging process. If the product is
switched off during the charging process, only the LED charge
display will continuously light up red.
7
A fully drained rechargeable battery requires approx. 3 hours
to recharge. The LED charge display
as soon as the charging process is complete. The battery status
symbol ,
14
Note: Prior to every use, check the display for the battery status
, and charge the battery if necessary.
14 31
If the battery drains fully while the camera is in use, the product
saves the current photo / video and then turns itself off.

Replacing the rechargeable battery

Switch the product off as described in the chapter "Switching the
product on and off".
Open the battery compartment cover
and lifting it up.
Remove the defective rechargeable battery / the battery you wish
to replace by carefully pulling the plastic strip.
Insert the new rechargeable battery (see chapter "Technical data")
and close the battery compartment cover
clicks into place.
, connect the product to a USB charging
56
. The notice
is shown on the LCD touch display
31
will show in the LCD
will only appear if the product
turns off automatically
7
by pushing it to the side
11
again, so that it
11
will light
7
.
5
GB/IE/NI 21