Maintenance - GFC MAGA Gebrauchs - Und Wartungsanweisungen

di gianfranco conti - 20021 Bollate (MI) ITALY - Viale Lombardia, 18 - Telefono 02 38302386 r.a. - Telefax 02 38302389
5.2.2 - Stopping and emergency operations
The machine has a stopping function, acting directly on that regarding start-up. Emergency stopping
is obtained through network sectioning, pulling out the plug.

6 - MAINTENANCE

6.1 - Cleaning
The machine requires no maintenance: for cleaning, insulate the machine by turning off the electri-
city. Eventual operations regarding the electric part inside the casing must be carried out by author-
ized and trained personnel. A danger signal will be given, if maintenance is carried out on electrical
equipment with the machine still connected.
7 - DIAGNOSTICS
Should the machine stop functioning, check the fuse in the rear feed connection group. For replace-
ment of same, utilize a fuse according to the material list attached to the diagram. To reach the fuse
group, it is necessary to insulate the machine from electric mains. A small box can be found in the
lower part of the group, in which the connected fuse is contained, together with the spare fuse. By
using the tang, it is possible to open the box, removing the most internal fuse and replacing it with
the spare one. Assure that the switch 1 is on position 0 (OFF). Having re-closed the box, it is possi-
ble to connect the feed cable again.
In the case of incorrect functioning and/or damages/breakdowns, immediatly pull out the plug and
put the general switch on the OFF position.
The machine is equipped with a thermostat, interrupting operation when demages or malfunctions
generate temperatures higher than those established. In these conditions, the machine must be insu-
lated subsequently contacting the assistance service for eventual interventins.
ANY INTERVENTION ON THE MACHINE MUST BE
REALIZED WITH THE ELECTRICITY TURNED OFF
ENGLISH
ATTENTION!
Rev. 0/96 Pag. 7 di 8