Herunterladen Inhalt Inhalt Diese Seite drucken

Operation And Use - GFC MAGA Gebrauchs - Und Wartungsanweisungen

Erhitzer
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 20
di gianfranco conti - 20021 Bollate (MI) ITALY - Viale Lombardia, 18 - Telefono 02 38302386 r.a. - Telefax 02 38302389

4 - OPERATION AND USE

4.1 - Operation
The machine is positioned on a table in front of the operator. The apparatus is turned on in order to
start heating a frame. Please remember that, after use, the machine must be turned off.
4.2 - Operator
Once the machine has been started, the operator concludes the operating cycle, subsequently stop-
ping it.
4.3 - Use foreseen
The machine is destined to heat frames and no other use must be made, other than that established
by the manufacturer.
4.4 - Safety warnings
- The machine must be utilized by skilled personnel and fully aware of existing dangers.
- Do not touch the hot surfaces.
- Do not use the machine near inflammable material, such as acetone.
- Do not introduce material through the suction vent-holes.
- Do not introduce liquids through the vent-holes.
- Do not open the machine before it has been turned off and cooled down.
- Do not block the air inlets on the instrument: this would jeopardize the correct functioning of the
machine.
- The two heating outlets are equipped with grates which permit a protection degree equivalent to
IP30, in the manipulation of filiform products, the use must nevertheless consider this protection
degree.
5 - INSTRUCTIONS FOR OPERATOR
5.1 - Control commands and units
The console of the MAGA frame heater is composed of:
1 SWITCH
2 SWITCH
3 SWITCH
4 REGULATOR
5.2 - Relative indications for use
5.2.1 - Start-up
The machine is started up through a voluntary action on a control device, acting as the general switch.
A selector for the interchange of the two power levels, a cooling selector, together with a potentio-
meter, modifying the temperature of the outgoing air flow, are all present on the panel.
I/O Command controlling general start-up of ventilator
ON/OFF Command controlling start-up of resistance
HI/LO Command controlling resistance temperature
Temperature regulator (with active resistance)
ENGLISH
Rev. 0/96
Pag. 6 di 8

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis