Lake People ADC F444 Bedienungsanleitung Seite 21

THE ANALOG to DIGITAL CONVERTER MODULE
THE DIGITAL OUTPUTS
The A/D part offers two digital outputs – bal-
anced and unbalanced.
Independent from their design, data words –
professional or consumer - on all outputs are
identical.
The outputs are situated on the rear panel and
marked to their function.
- The balanced output is equipped with an
XLR type connector and corresponds to
AES 3-1992,
impedance 110 ohms.
- The coaxial output is equipped with a cinch
connector and corresponds to IEC 958,
unbalanced, impedance 75 ohms.
HINT:
The level on this output complies with AES-id
regulations (1 Vss).
transformer balanced,
THE DIGITAL OUTPUT FORMAT
The digital output format - professional or
consumer - is selectable with the "FORMAT"-
button located on the front of the sync unit.
For more information about the setting see
"THE OUTPUT FORMAT" on page 18 .
HINT:
In consumer mode the SCMS (serial copy
management system) is handled as follows:
- Byte 0, Bit 2 = 1:
copy permitted / copyright not asserted
- Byte 1, Bit 7 = 1:
original / pre-recorded data
(if present, 1 or 2 modules)
21