Electrical Safety; Installation; Maintenance Instructions - Desoutter CVIXS Bedienungsanleitung

English

ELECTRICAL SAFETY

This controller must be earthed.
This product must be plugged into an outlet
properly installed and grounded in accordance
with all relevant codes and ordinances.
Never remove the grounding prong or modify the
plug in any way.
Do not use any adaptor plugs.
Check with a qualified electrician if you are
in doubt as to whether the outlet is properly
grounded.
If the tools should electrically malfunction or
break down, grounding provides a low resistance
path to carry electricity away from user.
GETTING STARTED
To setup controller:
● Refer to the 6159939280 user
manual at http://resource-center.
desouttertools.com
● Consult the local Desoutter
representative for support.

INSTALLATION

● See page 4.
The controller must be safely attached to
a support in order to prevent it for falling
down.
The controller should be installed in
such a way that it should be easily
switched off.
B
DIN rail mounting
● See page 4.
C
Angle support mounting
● See page 5.
D
Cables Connection
● See page 6.
Although our cables are designed
to work under drastic conditions, we
recommend that you check the following
points for longer service life:
● Bending radius should not be lower
than 10 times the cable diameter (c).
● Friction with the outer sheath should
be restricted (b).
● Any direct pull on the cable should be
avoided (a).
06/2019
E
Extension box connection
E1 - DIN rail mounting
● See page 7.
E2 - Angle support mounting
● See page 7.
F
Fieldbus module
F1 - DIN rail mounting
● See page 8.
F2 - Angle support mounting
● See page 8.
G
Switch on
● See page 9.
H
Fieldbus module
● See page 9.
When the fieldbus module is not into its
location, the cover must remain in place.

MAINTENANCE INSTRUCTIONS

Maintenance should be performed by qualified
personnel only.
● Disconnect from power supply and
wait 10 minutes before commencing
service operations.
Failure to wait 10 minutes may result
in electric shock from undischarged
capacitors.
According to Directive 2012/19/ CE
concerning Waste Electrical and
Electronic Equipment (WEEE), this
product must be recycled.
● Contact your Desoutter
representative or consult the website
"www.desouttertools.com" to find out
where you can recycle this product.
11 / 76
6159921180_08