Inhaltsverzeichnis
Werbung
6159933490_03
Original instructions.
© COPYRIGHT 2014, DESOUTTER HP2
7SJ UK
All rights reserved. Any unauthorized use
or copying of the contents or part thereof
is prohibited. This applies in particular to
trademarks, model denominations, part numbers
and drawings. Use only authorized parts. Any
damage or malfunction caused by the use of
unauthorised parts is not covered by Warranty or
Product Liability.
DECLARATION OF USE
MULTICVIL II System is designed to drive 2 to 32
multi spindle machine.
It consists of several CVIL II S modules according
to the number of connected tools and a CVIL II M
module to provide the interface between the PLC,
the PC and the slave modules.
Although it is possible to connect any tool of
the range, portable and fixture tools (ER; ERA;
EME), this equipment is mainly dedicated to
fixture tools.
The CVIL II M is the system intelligence: it fully
controls the tightening sequence, centralises the
controls and controls the CVIL II S modules.
The CVIL II M module doesn't drive any tool.
No other use permitted.
For professional use only.
EMC restriction of use: for industrial use only.
DATA
Weight
● 5.9 kg.
Normal environmental conditions
(for IEC 61010-1 standard)
● Temperature: 5°C to 40°C.
● Maximum relative humidity: 80% for
temperatures up to 31°C.
● Category II equipment.
● Altitude up to 2,000 m.
● Usable in pollution degree 2 environment:
indoor use only.
Line voltage
~
● (
) : Alternating current.
● The controllers support 100-120 V~ /
200-240V~ single phase, with automatic
switching voltage between 100-120 and
200-240 V~.
● Frequency 50-60 Hz.
Power
● CVIL II M:
20 VA.
● CVIL II S:
4500 VA.
SAFETY INSTRUCTIONS
General instructions
To reduce risk of injury, everyone
using, installing, repairing, maintaining,
changing accessories on, or working
near this tool must read and understand
the safety instructions before performing
any such task. Failure to follow all
instructions listed below may result
in electric shock, fire and/or serious
personal injury.
Caution: risk of explosion if battery is
replaced by an incorrect type. Dispose
of used batteries according to the
instruction.
General safety instructions are collected
in the 6159931790 tool safety booklet
and this manual.
Save these instructions carefully.
This symbol means:
Caution, risk of electric shock.
Electrical safety
Earthing connection
WARNING: this power tool must be
earthed.
They must be plugged into an outlet properly
installed and grounded in accordance with all
relevant codes and ordinances.
Never remove the grounding prong or modify the
plug in any way.
Do not use any adaptor plugs.
Check with a qualified electrician if you are
in doubt as to whether the outlet is properly
grounded.
If the tools should electrically malfunction or
break down, grounding provides a low resistance
path to carry electricity away from user.
The controller has a thermal protection and
a protection by means of over current and
differential circuit breaker.
Never replace the circuit breaker by a
model of higher value.
Never replace the circuit breaker by
short-circuit.
Circuit breaker characteristics:
● Voltage: 200-240V~.
● Max current: 16A.
● Curve: D.
● Differential sensitivity: 30mA.
14 / 100
English
12/2014
Werbung
Inhaltsverzeichnis
